EN
UARUENDEPL
+380 73 369 83 69Request a call
HomeBlogNitrogen refueling of the hydraulic hammer

Nitrogen refueling of the hydraulic hammer

Nitrogen refueling of the hydraulic hammer

Step 1: Get ready for work

Before starting the nitrogen filling process, make sure of the following:

The hydraulic hammer is stopped and is not in the working position. It is important that the hydraulic hammer cools down after work.

The tool is in a safe condition and you use appropriate protective equipment such as safety glasses and gloves.

You have the necessary tools and equipment, including a reducer with adapters, a nitrogen cylinder with a pressure regulator, and connecting hoses.

Step 2: Determine the pressure requirements

Before starting to fill, make sure you know the recommended nitrogen pressure for your hydraulic hammer model. This data can be found in the technical documentation supplied by the manufacturer or by contacting the service center.

Step 3: Connect the nitrogen cylinder

Attach the pressure reducer to the nitrogen cylinder, making sure all connections are tight.

Then connect the hose from the pressure reducer to the corresponding port on the hydraulic breaker. Depending on the model of the hydraulic hammer, there may be one or two nitrogen chambers. And the pressure in these chambers is different!

Step 4: Start refueling

Carefully open the valve on the nitrogen cylinder.

Use the pressure regulator to set the required nitrogen pressure in the chamber according to the manufacturer's recommendations. Usually, this happens by turning the gear knob.

Step 5: Monitor the pressure

Keep a close eye on the pressure gauge, which displays the current pressure in the hammer chamber. When the pressure reaches the required value, close the valve on the reducer and on the nitrogen cylinder.

Step 6: Check for leaks

After filling is complete, check all connections to make sure they are tight. If there are any leaks, repair them immediately, replace the nitrogen valve or O-rings.

Step 7: Complete the process

After successfully filling with nitrogen, close the valve on the hydraulic hammer and then carefully disconnect the hoses and the pressure reducer. Make sure everything is safe and secure.

Your hydraulic hammer should now be ready to go with a fresh nitrogen charge. It is important to follow this process according to the manufacturer's recommendations and follow all safety precautions. If you do not have experience in filling with nitrogen, it is better to contact professional specialists or a service center

All articles

Not sure what fits? We will match it to your equipment

Leave your phone number and our manager will select equipment for the weight of your machine and your soil.

Thank you! Our manager will call you back during working hours, Mon–Fri 9:00–18:00.
Could not send. Please call us: +380 73 369 83 69